30m Remote Control Access Control Advertising Barrier With LED
|Length of boom arm||Customized depend on demands|
|Arm plate number||Depends on the boom length|
|Advertising plate size||82x830mm|
|Screen size boxes||450x880mm|
|LED light power||16.7A,200 W|
|Barrier height after the lift||Depending on the arm length|
|Working speed||Generally for 5 seconds(Special requirements can be customized)|
|The arm center height||1050mm|
|Input interface||+12 Level signal or pulse signal is greater than 100ms,the derive
current of less than 10mA|
Advertising Barrier Features
1.1 Advertising barrier’s house is durable and water-proof, so it
can be used outdoor.
1. 2 Appearance is simple and generous with advertising lamp house
And advertising board. Advertising board can be dismantled, and
easy to change advertising photo, All operation is simple.
1.3 Both barrier housing and arm plate are equipped with LED
lights, the LED lights can be controller via timer(it can be set
like this: close in day time and open at night).
1.4 Combination of lights, electricity and mechanical control.
Operation is flexible and convenient. Safe and reliable in use
1.5. Multiplex control way are provided for user: push button,
remote controller, long range reader etc.
1.6. Adopt multiple protective measures (like anti-wind, preventing
motor overheat, Anti-surge, Thunder-proof and so on),which increase
barrier’s safety and reliability.
1.7. Add loop sensor, following functions can be realized: auto
close, auto bounce up etc.It can automatic closing gate and perfect
preventing smashing car.
1.9. System adopts standard electric interface which can connect
with other system easily.
1.10. Barrier is adjusted to prefect conditions before leaving
factory: it is stable, lower noise, long service life.
Advertising Barrier Security Features
2.1. Pressure sensor: During closing, arm will auto bounce back if
it meets any resistance
to reduce damage(pressure sensor is with function of
2.2．Loop sensor: Arm will open automatically during closing If
controller gets signal from
the sensor. Barrier cannot be closed till loop sensor trigger
signal off. And loop sensor
will close barrier automatically after signal.
2.3. Open first function: No matter what barrier arm status is,
gate will carry out open
order at once when open signal is got.
2.4. Protective rubber: Rubber is fix at the arm bottom. It can
minus damages if any
Advertising Barrier Installation Instruction
1. Install main arm: After fixed barrier housing, insert main arm
into arm holder, and fix it via M10*90 screw, and then insert LED
light wire into housing via main shaft.
2. Fix connect rod parts: Using M5*20m screws and butterfly nuts to
fix connecting rod on housing holes.
3. Fix small arm on connect rod: Using M8*70 screws to connect rod
with small arm,and fix connect rod.
4 .Install poles: First use stays webs make stays to connect, and
M5*20 screws lock; then use stays’ connecting axis across main and
sub-boom arm, finally use lock-nut to lock
5. Install advertising plate: Insert the plate into arm groove
(notice: arrow face down). And use screws to lock cover.
6.Debugging: After finished arm assemble, use handle to open and
close the barrier.After checking everything is ok, connect power to