Manual Operation Tripod Turnstile Gate, Turnstile Gate for
turnstile which widely used to integrate with magnetic cards,
barcode cards, ID or IC cards to manage the passages in hotel,
factories, communities and enterprises, etc.
|Power Supply||AC220V±10V ,50Hz / AC110V±10V ,60Hz|
|Temperature||-30 to 60 degrees|
|Humidity||<95%, without concretion|
|Passing Speed||30 persons/min (normal open), 20 persons/min (normal close)|
|Arm Open/Close Time||2s|
|Input Interface||+12V electrical signal or impulse signal with width more than
|Communication Interface||RS485 (Distance: <=1200m)|
|Size||Uni-direction or Bi-direction|
Tripod Turnstile Gate Main Functions
1) Running stable, little noise and no mechanical impact
2) Various working means can be set in the control panel menu,
namely:bi-direction card reading passing, or one direction card
reading passing and another passing limits, or one direction card
reading passing and another free passing, etc.
3) If power off, arm will fall automatically while power on later,
lift arms manually for semi-automation type. (And arm will be
automatically lift if power on for full-automation type.)
4) It is with RS485 connection for far control arm up and down to
satisfy the special needs or fire control requirements.
5) It is with standard electrical interface to connect various
kinds of readers and
writers for easy integration and also computer far control and
be realized by computer.
6) It will count the persons who have been passed through
automatically and will show the number by LED directly.
7) Re-position function. After card reading, if passenger not
through within the specific time, system will auto cancel passing
right for this time and the limit passing time length can be set.
8) Self-checking-power-on function, if power on, turnstile will
auto get to be held.
1. Check the spare parts according to the parking list.
2. Make sure the place where to install turnstile according to
system components, place features and turnstile type.
3. Confirm installation holes according to the following
drawing.Pre-bury 4 pieces of M12 anchor bolts or 4 pieces of M12
4. Put the strong electrical cable and the weak electrical cable
inside the 3/4¡± PVC tubes respectively and bury them into its
5. Open the door of turnstile, aim anchor bolt to the turnstile
base hole and tight the nut.
6. According to the system connection drawing, make the
power,control cable and turnstile control panel cable connected as
well as the protection ground cable.
The tripod turnstiles can be used in places such as restaurants,
hotels, office buildings, museums, gyms, clubs, metros, bus
stations, high class communities, intelligent buildings, hotels,
subway stations and other high level venues, ect.